Kiemelt kollekció
Kosár
Kiemelt kollekció
PEAK SURGICALS
Termékváltozat:PS-M-105
Nem sikerült betölteni az átvehetőségi adatokat
The Aderer 3-Prong Orthodontic Wire Bending Pliers are specialized orthodontic instruments designed for controlled bending, contouring and adjustment of dental wires. Also known as three-jaw or three-prong pliers, the instrument uses one opposing prong against a two-prong working end to create controlled bends in orthodontic wire.
This configuration is widely used in orthodontic laboratories and clinical environments where wire must be shaped, adjusted or contoured before or during appliance fabrication. The polished instrument design provides a professional working surface suitable for routine orthodontic bench and chairside use.
The defining feature of the Aderer plier is its three-prong working end. One side contains a single working prong while the opposing side uses two prongs. When the handles are closed, the central prong acts between the opposing pair, allowing the operator to place controlled bends into compatible orthodontic wire.
This configuration distinguishes the Aderer plier from bird-beak and conventional flat-jaw orthodontic pliers. It is particularly useful when progressive bends or wire contours must be created without relying on cutting jaws.
Aderer pliers are intended for orthodontic wire manipulation rather than wire cutting. They can be used when forming or modifying compatible orthodontic wires and clasps according to the clinician's or technician's required appliance configuration.
The three-prong geometry provides multiple contact points around the wire, helping the operator create repeatable bends while maintaining direct manual control. The amount and direction of the bend can be adjusted according to wire type, appliance design and professional technique.
The instrument is suitable for orthodontists, dentists, dental laboratory technicians and orthodontic training environments. It can be incorporated into workflows involving archwire adjustment, clasp fabrication, appliance wire forming and other appropriate orthodontic wire-bending tasks.
Peak Surgicals' own orthodontic guidance identifies three-prong pliers as instruments with two prongs on one beak and one on the other, used for adjusting wires and clasps.
The corresponding supplied Aderer 3-prong plier is marketed as a German stainless steel orthodontic wire-bending instrument. The polished all-metal construction provides a rigid platform for controlled wire manipulation while allowing the working surfaces and joint to be visually inspected between uses.
The smooth joint and elongated handles support controlled opening and closing of the three-prong working end during detailed wire-forming procedures.
| Product Name | Aderer 3-Prong Orthodontic Wire Bending Pliers |
|---|---|
| Instrument Type | Orthodontic Wire Bending Pliers |
| Pattern | Aderer / Three-Prong |
| Working End | 1-Prong Opposing 2-Prong Configuration |
| Material | Stainless Steel |
| Finish | Polished |
| Primary Application | Orthodontic Wire Bending, Contouring and Adjustment |
| Intended Users | Orthodontists, Dentists and Dental Laboratory Technicians |
| Brand | Peak Surgicals |
Clean and process the pliers according to the dental facility's validated instrument-processing procedures and applicable product-specific instructions. Inspect the three working prongs, joint and handles for deformation, surface damage or retained residue before use. Do not use the instrument as a wire cutter unless the specific product configuration is expressly designed for cutting.
They are used for controlled bending, contouring and adjustment of compatible orthodontic wires and clasps.
One working side has a single prong while the opposite side has two prongs, creating a three-point wire-bending configuration.
No. This configuration is intended primarily for orthodontic wire forming and bending rather than cutting.
The corresponding supplied model is listed as stainless steel.
The product is identified as a polished-end Aderer plier.
They are suitable for orthodontists, dentists and dental laboratory technicians performing appropriate wire-forming procedures.
